CW250 Stepper Driver Controller for CNC Router Step Motor Driving

CW250 Stepper Driver Controller for CNC Router Step Motor Driving

This stepper driver is CW250 2 Phase Microstepping Stepper Motor Driver, 8 subdivide, 20-60VDC 5A, controls the nema23 nema34 stepping motor and 57 86 serial stepper motor, widely used on small size CNC router engraving machines.

CW250 Stepper Driver Parameters:

1, Input Voltage: 20 ~ 60VDC single voltage supply.

2, Phase Current: the current module can be adjusted (0~5A).

3, Drive Mode: full bridge drive.

4, Fine Points: 1/8, 1/2 (the whole step is 1.8 degrees).

5, Operating Characteristics: better than the original motor factory indicators.

6, Protection Form: over heat protection, lock automatic half flow.

7, Size: 140mm * 94mm * 45mm

8, Weight: <500g.

9, Operating Environment: temperature -15 ~ 40

10, Humidity <90%