CMM1-10 Hydraulic anchor drill truck for coal mine

Product introduction of cmm1-10 hydraulic anchor drill truck for coal mine

Cmm1-10 hydraulic anchor drill truck for coal mine is a new multi-purpose drill truck developed by our company for the anchor installation of underground roadway in coal mine.The vehicle is small in size, light in weight, flexible and multi-use, and has good passability.It can also be used for underground water detection, gas detection, ground anchor shooting, mesh repair in roadway and stopping anchor network in fully-mechanized mining face.

Main features of cmm1-10 hydraulic anchor drill truck for coal mine

1. Caterpillar walking is adopted, which can well adapt to the pit and muddy ground conditions in the underground.

2. Electric drive, full hydraulic control.

3, drill arm can rotate 360 °.

4. The drill arm can be used as a platform, which can be equipped with both water-exploring drill and anchor drill.

Working principle of cmm1-10 hydraulic anchor drill truck for coal mine

After the drill truck pump station is started, the drill truck is moved to the required position through the pilot operation valve behind the drill truck to prepare the drilling operation;Drill arm consists of connecting rod arm, cross arm, can keep the drill department level lift, installed on the rotary department can rotate 360 °, through the pilot operated valve jumbo drill arm, and carry on the drill arm of anchor drill or ground water drill stretch to the right punch position, start drilling operation.

Main technical parameters of cmm1-10 hydraulic anchor drill truck for coal mine

Parameter name unit parameter remarks

Drill truck size (length x width x height) m 5.4x1x1.8 tightening

Height of horizontal borehole m is less than or equal to 3.45

Walking speed m/min is less than or equal to 20

Climbing ability (°) + 12

The hole diameter Φ 28 ~ Φ 50 mm

Rated pressure MPa 16

Ground water drilling rig

Rated speed r/min 210

Rated torque N.m 500

Drilling depth m 0~100

Drilling rate m/min 0~1.5

jumbolter

Rated speed r/min 460

Rated torque N.m 300

Depth of one drill m 2.4

Drilling rate m/min is greater than or equal to 1

Borehole inclination (°) + 90

Drilling horizontal (°) + 180

Cylinder thrust sliding rack cylinder kN 14

Machine weight t 6