RTV molding silicone rubber for plaster products
Specifications
RTV molding silicone rubber for plaster products feature:
(1) RTV molding silicone rubber for plaster products with SGS and ROSH approval
(2) Curing agent arrange together as free charged
(3) In liquid form and in various colors
(4) With an exceptional fluidity and good operability.
(5)Temperature and deformation resistance as well as low shrinkage.
(6) High duplication times.
(7) Sample orders are available
RTV molding silicone rubber for plaster products datasheets:
| Model | Color | Mixing ratio (%) | Pot life (mins) |
Demould
time ( hrs) |
Hardness ( A0 ) | Tensile-strength | Tear-strength |
Viscosity
(mPas) |
Shrinkage
rate (%) |
Elongation
(%) |
| 630# | white | 100 :5 | 30-40 | 3-5 | 29-31 | 49kgf/cm2 | ≥ 33kgf/cm | 27000 | ≤0.3% | 490% |
| Dowcorning3481 | white | 100 : 5 | 30-45 | 5-6 | 22-25 | 4.6Mpa | 23kN/m | 25000 | ≤0.5% | 520% |
| Bluestar (3325 /585) | white | 100 : 5 | 20-60 | 6-24 | 25-28 | 4.2Mpa | 26kN/m | 35000 | ≤0.7% | 440% |
| Wacker®M4503 | white | 100 : 5 | 30-90 | 10-20 | 25 | 5.0(N/mm² | > 20N/mm | 40000 | ≤0.5% | 350% |
| SmoothonMoldMax®25 | white | 100 : 5 | 45 | 24 | 25 | 577psi | 130pli | 25000 | 002 in./in. | 375% |
RTV molding silicone rubber for plaster products operation way:
Step One:Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly.
Step Two: vacuum pumping.Without exception, this step takes less than 10 minutes.
Note: The time for vacuum-pumping should be less than 3—5 mins , otherwise, once the silicone rubber has cross-link reaction during vacuumizing, it will not be operated.
Step Three: Brushing cast & Perfusion Molding operation
Need any help on silicone rubber, please feel free to contact Mskaka:
Tel:86-755-89212365
Mob/Whatsapp:86-18938867528
E-mail: hyk(at)resinpu(dot)com
Skype:hyk(at)resinpu(dot)com
