Helical gear reduction motor SEW type

GR series helical gear motor

R series (two-stage and three-stage)
Our complete range of helical gearmotors provides the optimum size and power solution for every drive task. And for operators with our multi-stage gear units provide something special: Thanks to their die-cast aluminum design, the models R07, R17 and R27 are three particularly efficient lightweights ��?ideal as satellite drives and for use in light machine constructions. Reduced backlash helical gear units are also available for particularly precise requirements.

//

Characteristics of product:

1.High modularization design: may equip with various motor or other power input conveniently. Same machine type may equip with various power motor. It is easy to realize the combination and junction between every machine type.
2.Transmission ratio: fine division, wide scope. The combined machine type may form very large transmission ratio, i.e. output very low rotary speed.
3.Form of installation: the position to be installed is not limited.
4.igh strength, compact: the box body is made of high strength cast iron. Gear and gear shaft adapts the gas carbonization, quenching and fine grinding process, therefore the bearing capacity of unit volume is high.
5.Long life: Under the condition of correct type chosen (including choosing suitable operation parameters) normal operation and maintenance, the life of main parts of speed reducer (except wearing parts) should not be less than 20000 hours. The wearing parts include lubricating oil, oil seal and bearing.
6.Low noise: because main parts of speed reducer are processed, assembled and tested critically, therefore the noise of speed reducer is low;
7.Parallel axis -bevel wheel speed-down motor.

//

//

1.The box body is made of high strength cast iron. Gear and gear shaft adapts the gas carbonization（HRC58-62 quenching and fine grinding process, therefore the bearing ，capacity of unit volume is high.
2.A good performance of rustproof for both inside and outside:three spraying paint totally, first antirusting paint;then Midcoat,last topcoat.
3.Smooth and stable in run，Low noise: because main parts of speed reducer are processed, assembled and tested critically, therefore the noise of speed reducer is low;
4.High in transmission efficiency: the efficiency of single machine is not less than 95%.
5.It may bear the axial load that is not more than 15% of radial force.
6.Long life: Under the condition of correct type chosen (including choosing suitable operation parameters) normal operation and maintenance, the life of main parts of speed reducer (except wearing parts) should not be less than 20000 hours. The wearing parts include lubricating oil, oil seal and bearing.

/