Flat plate auto blister packing machine

Product Description

The machine conforms to GMP requirement and is suitable for aluminum-aluminum, aluminum-plastic,

paper-plastic packing.

Product Specify:

The machine is the latest product in our company adopting PLC, frequency converter, and man-machine

interface. It can check on-line and eliminate the waste plate by itself. In accordance with GMP rule

requirement, it is an ideal blister packing machine for aluminum-aluminum, aluminum-plastic, paper-plastic

packing. And it has got highpopularity.The products have been appraised as the provincial science and

technology accomplishments.

Features:

1. Equipped with fiber-optic checking mechanism, which can eliminate by itself the waste plate with lack of

medicine, thus gain a qualified recovery rate of 100%.

2. Blister forming, heat sealing, lot number printing, avulsion line impressing and cutting etc all adopt gear

mandrel orientation, each can move freely in the mandrel when rotating the hand wheel, and the machine

equipped with a staff gauge and tightening nuts for calibration and orientation.

3. Forming mould, heat-sealing mould and pressing mould adopt bolt orientating, with features of accuratet

orientation, easy to change moulds and material saving.

4. All the movement of heating, forming, upper and lower net veins pressing, air cylinder pressing, feeding, lot

number printing and cutting can be done very simple, automatically and accurately.

5. Main transmission part adopts parallel axis and bevel wheel speed reducer, with stable running, low noise and

long service life.

6. The forming of hard Aluminum of other factories adopts the concave-convex coordination to lock the mold

and it will leave behind a scoop channel on the plate. The travel range must be prolonged above 2mm, so that the

scoop channel will be cut as scrap. It is calculated the scrap sum up to several hundred thousand Yuan annually.

The forming of hard Aluminum with our equipment adopts the imported & special rubber lock mold. The surface

of the molding is smooth. Each cutting will save above 2mm the material (approximately 2.5%). Because the price

of cold forming aluminum is expensive, Massive materials will be saved annually by using our machine. Thus the

economic efficiency is remarkable.

7. The body of machine is manufactured separately in order to move the machine into workshop conveniently.